Attaching the secondary brake lever

 

The secondary brake lever which is hanging from a cable and attached to an aluminum stub, must be inserted into the front hole of either of the two side rails that form the seat. Make sure that the lever is securely located and securely tighten the clamp with a 5mm allen wrench.

 

 

 

 

 

 

 

Installing the hand grips

 

After you have unpacked your handgrips which come mounted on crank spindles, you are ready to attach them to the Crank arms.  Notice that the black threaded portion of one of the spindles has a groove, and one does not.  The one with a groove is the left-hand grip and the one without a groove is the right-hand grip.  The spindles thread into the holes on the crank arms.  NOTE:  The left-hand grip spindle is REVERSE threaded.  Using a 6mm Allen, tighten counter-clockwise as shown.  The right-hand grip is not reverse threaded, tighten it clockwise. 

 

 

This completes the assembly.